| View previous topic :: View next topic |
| Author |
Message |
MarkKiteGuy
Wind Seeker
Joined: 17 Dec 2005
Posts: 2
Location: florida
|
 Posted: Mon Dec 19, 2005 10:15 pm Post subject: need a mesurment for new jam |
 |
|
can anyone give me a measurement for the stops on the upper spreader as when i recived my "new jam" they were in diferent positions and thefore causing a symetry problem...
mesurment from nose to stop.. or measurement from leading edge cut out neer nose to the stop. either would help...
thanks to whoever replies. |
|
| Back to top |
|
 |
Chris
Mile High Club
Joined: 12 May 2005
Posts: 228
Location: Austin, TX
|
| Posted: Tue Dec 20, 2005 6:34 pm Post subject: |
|
|
Hi Mark,
The stop is roughly 30.5 cm from the top of the leading edge spar. The leading edge cut out should give you a good indication of inequities. The stop is normally positioned just below the center of the cutout, allowing the APA to occupy the center.
I hope this helps.
Chris
_________________
"Fly a kite for a child and you entertain them for the day. Teach a child to fly a kite and you entertain them for life." |
|
| Back to top |
|
|
MarkKiteGuy
Wind Seeker
Joined: 17 Dec 2005
Posts: 2
Location: florida
|
| Posted: Wed Dec 21, 2005 9:53 pm Post subject: thanks chris |
|
|
| thanks for the info... |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
